AV-advance Stereo MiniJack with USB trigger cable to B&O Powerlink

B & O compatibel adapter-cable based on audio kabel i good quality, mounted with goldplated stereo 3,5mm Minijack for analog audio as well as trigger cable, mounted with USB plug, the exploitation of USB "trigger" from example PC, MAC, USB-powersupply or other which can supply via USB. This cable has 8-pins DIN female-plug, that gives the opportunity to pass signals in existing or new Powerlink cables and are you using 2 Powerlink cables, you can split the signal with a PowerLink splitcable Pay attention to that your B & O Beolab will remain ON Untill USB power is disconnected . Just remember to set the little switch in your B & O speakers to either 'L' or 'R' depending if it is Left or Right speakers.

Be aware that your B&O sepakers will remain on untill the USB connetion is disconnected. If this adaptorcable is used with usb port on a tv, it is possible that this usb port is allways on. In some cases this can be regulated in the setup menu in the tv, so that the usb port turns on and off together with the tv.
You might experience some noise in the speakers when you use this with at tv. The cause might be noise comming from either headphone or usb output on the tv. We have primarily experienced this on Beolab 7.1/7.2/7.4., so for these we recommend full mounted MK2 powerlink cables
This might not solve the problem with noise in the speakers, and unfortunatly we do not have a solution for this issue.

Do you need 2x Phono instead of Minijack, you can convert with this adapter: Minijack phono adaptor . This should not be used into stereo phono output from a tv, because you typically can not adjust the volume when using this output .

This setup can be used with all B & O Beolab speakers with Powerlink, except Beolab 5 speakers.

– Of total 25 ratings