AV-advance Mono/1 channel phono RCA and trigger cable to B&O Powerlink

Home

Return goods

Finansing

Stores

Information

B2B sales

Tel. +45 7442 1078 (weekdays 9-17)

Fast worldwide delivery

Price protection

30 days return policy

Mono adaptor for connecting surround / stereo equipment with pre-out and 12V trigger for B&O BeoLab speakers with Powerlink.

Starts at 20 EUR /pc.

Choose variant for price and delivery

AV-Connection

Fast worldwide delivery

+25 years of experience

30 days return policy

5-star customer service

Price protection

B & O compatible adaptor cable based on audio cable in good quality, fitted with gold plated phono plugs and trigger cable fitted with Mini Jack (mono) male connector to use 12V trigger from 3rd party surround / stereo equipment. The cable comes out in an 8-pin DIN female connector that gives the opportunity to pass signals in existing or new Powerlink cables.

The cable is constructed with an internal 12-5 volt step-down for the protection of B & O speakers Powerlink port normally specified for max 5V (2.5V-5V in switched mode) and when you use a cable without internal step-down, you will supply the speaker Powerlink port with 12 Volt, which at worst can go and short circuit the powerlink plug of the speaker. Notice that this adaptor cable takes care of the problems you have when using third-party stereo or surround equipment with a 12V trigger for on / off of external devices with B & O speakers.

Note: Some people may experience a humming or hissing sound in their speakers if you connect this trigger cable to certain brands of amplifiers / processors. This is due to the ground connection that is on the mini Jack trigger connector. However, this can be removed using a trigger power adapter .

Some active B & O speakers have a standard. line input (RCA RCA 'Line'), which the speaker can trigger on and it is basically also a good solution with a third-party system wich is used for music, but when you use B & O speakers in a surround setup, there is a risk that the speaker switches off during quiet passages in the movie and the speaker then can take a while to start up when there is passages with sound again. The problem with on and off switching does not happen with this trigger cable, since it ensures that the speaker is turned on as long as the amplifier (trigger) is on (remember that the little switch in B & O speaker must be either ' L 'or' R 'depending on whether it is Left or Right speaker).

Active B & O speakers which are equipped only with a Powerlink such as BeoLab 2 BeoLab 11 BeoLab 7-1 and BeoLab 7-4 etc. can take advantage of this cable because you dont have the option to use line input on these.

Notice: Can be used for all B & O BeoLab speakers with Powerlink, except BeoLab 5 & Beolab 5000 speakers - CAN NOT BE USED FOR BEOLAB 5 AND BEOLAB 5000!

Cant NOT be used for Link speakers with Masterlink such as Beolab 3500 and others

Do you need more trigger/DC outputs?
If you need trigger / DC outputs on your amp / receiver, you can use the following adaptor in small installations: HQ-ADAP010 and for larger installations you can use AV advance Trigger 1-to-6 splitter adaptor cable.

Specifikation:
• Stereo version
• Goldplated phono male-plug (Audio)
• Goldplated MiniJack male-plug (12V Trigger)
• 8-pins DIN PowerLink female-plug (Audio + Trigger)
• Audiocabel in a godd quality
• 12V to 5V Step-down (B&O PowerLink protection)

Here you can see how other customers have rated the item with character, and possibly made a review.

Average rating (5,0):

– Of total 11 ratings

Godt kabel ☺

Fungerade perfekt för min Yamaha AV-R667 med 12V utgång och Beolab 7-4. Jag var initialt orolig för att DIN-kontakten var en hane, men det är en hona och det är således enkelt att använda den existerande kabeln som en förlängning. Snabb leverans dessutom!

AV-TRMDIN8: AV-advance Phono + Trigger to Powerlink, mono audio adaptor, center/sub channel (Phono RCA male, MiniJack - 8 pin DIN female) | 35 cm

AV-TRLDIN8: AV-advance Phono + Trigger to Powerlink, mono audio adaptor, left channel (Phono RCA male, MiniJack - 8 pin DIN female) | 35 cm

AV-TRRDIN8: AV-advance Phono + Trigger to Powerlink, mono audio adaptor, right channel (Phono RCA male, MiniJack - 8 pin DIN female) | 35 cm

Since AV-Connection's inception in 2000, we have specialized in offering a range of specially manufactured signal and speaker cables, adapters and accessories, often according to customer requirements for length. We produce adapters and cables where they are not available from the manufacturers in the desired design, quality or length.

Please note that there is NO right of return on cables that are manufactured according to customer requirements for special lengths.

Manuals and user guides for AV-advance products

Unfortunately, as manufacturers do not make manuals or guides in all languages, we cannot guarantee that a local language manual is included for the item.
- If you are unsure about a manual available in the desired language, just contact us and we will do what we can to help.

Customer service

• About AV-Connection

• Customer references

• Sales conditions

• Return and complaints

Webshop info

• Shipping / delivery

• Payment

• Price match

• Login

News and events

• Product news

• Sale and Outlet

• Promotional offer

• Newsletter

Shops

• Denmark, Odense

• Denmark, Sønderborg

• Webshop

• Business sales / B2B

Newsletter sign up

All prices are incl. 25% danish VAT/Tax

AV-Connection A/S • VAT no.: DK27907547 • Kaervej 71-73 • 6400 Soenderborg • Denmark • Tel. +45 7442 1078 • E-mail: [email protected]

© Copyright AV-Connection A/S. All images and texts on the website are copyrighted and any copying without specific permission is prohibited. Copying and photographing of the website with sales in mind is prohibited under sections 1 and 2 of the Copyright Act. Parties who do not comply with this will be required to pay compensation and be prosecuted in accordance with section 38.

AV-advance Mono/1 channel phono RCA and trigger cable to B&O Powerlink

Mono adaptor for connecting surround / stereo equipment with pre-out and 12V trigger for B&O BeoLab speakers with Powerlink.

Brand description - AV-advance

Manuals and user guides for AV-advance products

All prices are incl. 25% danish VAT/Tax